
Flow
Fifteen rings in a lobby and up an open courtyard, every pixel made from scratch.
- Client
- Moxy Hotels, with Moment Factory
- Partners
- Moment Factory, design and content
Tesseract, ring mechanical design and fabrication management - Our role
- LED pucks, electronics, power, data, control and installation
- The software
- Moment Factory's TouchDesigner shows run on the control system we built, the rings playing as one field of light.
- Today
- Handed over in January 2019, with a maintenance manual of our own for finding and swapping a puck.
- 1,360
- Pucks
- 15
- Rings
01 · The idea
Light that flows up and away
Rings of points of light rise from a hotel lobby up an open courtyard, so a single show moves through a volume as tall as the building. Seen from below, the light flows up and away.
At the Moxy in San Diego, Moment Factory designed a series of rings strung with points of light, hanging under the lobby skylight and up the courtyard beside it, through 2016 and 2017. In October 2017 we bid to make it real, from their technical design. The challenge was to stay true to it while building something that would last for years in an open-air atrium. So we made every point of light ourselves.


02 · The present
Moment Factory's shows
Moment Factory programmed the shows in TouchDesigner, played across the rings as one field of light. We gave them the control system their animations needed.
03 · How it's built
How it's built
Prototypes and a crane
We designed the puck through the spring of 2018: housings modeled and prototyped, a first board in April and a second in May, and diffusion tested on the prototypes. In mid-2018 the rings were redrawn as tubes, and Tesseract managed their fabrication, with Ferguson Welding Service welding them. In September the strands were assembled, the electronics mounted and tested, and the rings trucked to San Diego. On site we installed it ourselves with a hired crane crew: the courtyard stack was rigged ring by ring and flown in as one piece.
- Rings, by Tesseract
- LED runs, by Digital Ambiance
- First light
One pixel, twelve LEDs
Each puck is one pixel: twelve RGB LEDs, six to a side, behind a faceted diffuser, on a board we designed with its own power regulation, coated to keep out the weather. Power and data share one three-wire cable, and the pucks are tied to tensioned steel cables, in crescents in the courtyard and straight lines in the lobby.
We sized the drivers ring by ring and ran the data as Art-Net to PixLite controllers that drive the pucks, over the hotel's own network, so the content could play across every ring as one volume. Clark Reder analyzed the structure for Tesseract, and the lobby cables are angled out to limit sway in an earthquake.
04 · Credits and operation
Back after two months
Two months after opening we were back on site, replacing parts and updating the show's addressing. In January 2019 we handed over the closeout package, the warranty and a maintenance manual of our own, with tests to find a stuck pixel and the steps to swap a puck.
- Installed
- September 2018
- Client
- Moxy Hotels
- Design and content
- Moment Factory
- LED pucks, electronics, power, data, control and installation
- Digital Ambiance
- Ring mechanical design and fabrication management
- Tesseract
- Welding
- Ferguson Welding Service
- Structural analysis
- Clark Reder Engineering
- Photography
- Langoworks






